XFX 680i LT OC - NTUNE doesn't work?

[B.I.T.]

Hello everyone, this is my first post here, you guys are doing a nice job, keep it up. I am using an E2160 on my XFX 680i LT, everything works fine, very plesed with my choice, but the only thing it doesn't work is NTUNE - i can not use it for OCing, the only thing i can change it is FSB, nothing else like Voltages or Fans speed..., little help pls? Many thanks, B.I.T.

[xfxsupport]

Are you using Windows Vista or XP? I did try with Vista and Ntune would not adjust the voltages. You can however go into the bios settings and manually chance the voltages there. Let me check to see if I can get ahold of a new Ntune and test it out.


XFX Support

[B.I.T.]

Thanks for your reply, i am using XP, and BIOS P04. If u need more info about my system specs, let me know, i'm trying to set up my signature, many thanks, B.I.T.

['Amp!']

If I may offer my experience.

When you install your Nvidia motherboard drivers if you select to NOT install the ide drivers (these are crap but you should) then Ntune will have many problems.

I ran into the same problem and then when I reinstalled everything this time including the IDE drivers my Ntune worked flawlessly.

I couldn't figure it out for the longest time. It is really annoying since installing the ntune drivers causes all my SATA drives to show up as USB connected devices on my little taskbar. They all operate at their full speed it is just windows that things they are connected via USB.

Give that a try.

[Bio-Hazard]

Everything in nTune worked on my 680i LT board while I had it installed (now in for RMA). The only thing I used nTune for was to monitor the system temps, I OC my system manually in the system Bios, nTune has a bit of a problem over volting much higher than required for the OC causing the temps to run much higher than necessary. Do yourself a favor and dump ntune for OC'ing you'll be glad you did in the end.

[B.I.T.]

I 've reinstalled the drivers, nothing's changed. I can not use NTUNE. I know what u want to say about bios settings for OC, but i need to use the fan control features from time to time, too many fans... BIO-H which version of NTUNE are u using?