OCZ Reaper PC6400 Question

[Methious]

Here's some test data from the Mushkin kit I was using, and data from the Reaper kit.
Thought it might be useful to see what I've done with it so far.

So far I've had it up to 900 stable, @ 5-5-5-15 @ 2.05v, it's got crazy SPD timings in
CPU-Z ranging from 1.8v loose timings to 2.0v @4-4-4-15 Specs on the website say
2.1 at 4-4-4-15 so I went middle ground @ 2.05v.

Extended voltage protection says I can go to 2.2v (like they'd know if I went a lil higher),
so the question is:

Think I can get the Reaper to hold 4-4-4-15 (or 4-4-4-12) @ 3.52 CPU speed with a little
more volts, or have to loosen the timings for stable? Haven't ventured into the 3 timing set
yet, mobo in sig is limited to 2.25 vdimm.

Mushkin @ 5-5-5-12 Stock settings @ 3.2 GHZ cpu speed
http://i243.photobucket.com/albums/ff255/methious/reaper/Mushkin5-5-5-12.jpg

OCZ Reaper @ 4-4-4-15 Stock Settings @ 3.2 GHZ cpu speed
http://i243.photobucket.com/albums/ff255/methious/reaper/Reaper4-4-4-15.jpg


Mushkin @ 4-5-4-12 Tightened Settings @ 3.2 GHZ cpu speed
(timings closer to the stock Reaper timings)
http://i243.photobucket.com/albums/ff255/methious/reaper/Mushkin4-5-4-12.jpg

Mushkin @ 5-5-5-12 Stock @ 3.52 GHZ Cpu Speed
http://i243.photobucket.com/albums/ff255/methious/reaper/Mush5-5-5-12352.jpg

Reaper @ 5-5-5-15 Loosened @ 3.52 GHZ Cpu Speed
http://i243.photobucket.com/albums/ff255/methious/reaper/Reaper5-5-5-15352.jpg

Reaper @ 5-5-5-15 Looser Timings @ 3.6 Ghz Cpu Speed (Dropped multiplier to 15 raised FSB/HT to 240, lowered HT from 5 to 4, vcore 1.45, vdimm 2.05v)
http://i243.photobucket.com/albums/ff255/methious/reaper/Reaper4-4-4-15360.jpg