View Full Version : Monitor ms question in eyefinity
11-14-2012, 09:56 PM
Would it be an eyesore to have a 3 monitor setup with eyefinity and have 2 monitors with 5ms response time and 1 with 2ms response time?
11-14-2012, 10:00 PM
An eyesore? Probably not. If anything, what would be an eyesore would be the bezels being a break between the three monitors. That, and if one of the three monitors has a different resolution. Then, all three monitors would be running off of the lowest resolution monitor of the three. That would be the most eyesore of anything.
11-14-2012, 11:18 PM
well what I was concerned with is weather there would be some sort of ghosting or breaks in frames due to the difference in ms
11-14-2012, 11:21 PM
The only thing that is a known issue with AMD's Eyefinity is the screen tearing thing. From what I understand according to AMD, the screen tearing is a result of two different things:
1. The signal being sent from DVI / HDMI is sent to the monitors at different frequencies than those of the DP / MDP ports.
2. Driver related issue
The one thing that can alleviate this to an extent is to have all identical monitors.
11-17-2012, 05:21 PM
If everything is relatively the same except response then you wont see a difference.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.